The Thunderverb 50 is a Twin Channel Class A/B amplifier. All valve, 50 watt RMS, channel-switching head with foot switchable attenuator, valve FX loop and valve-driven reverb. This amplifier sports two clean/crunch lead channels, each with three stages of gain. Channel A has the same three band EQ as the lead channel used on the Rockerverb series. Channel B has a new shape control that scoops the mids and decreases the bass and treble when turned up. Use this scoop knob to dial in everything from vintage rock to modern blues, hard rock to metal.
The Thunderverb 50 also has a foot switchable attenuator. Dial in your rhythm tone at a lower volume, then active the attenuator to boost the volume for really loud breaks, all without affecting your tone!
Two foot switchable channels
Foot switchable valve reverb
Valve FX loop
Foot switchable attenuator
Channel A: volume, treble, middle, bass
Channel B: volume, shape, gain
Power amp: 2 x EL34
Preamp: 4 x Ecc83/12ax7
Reverb: 1 x Ecc81/12at7
FX loop: 1 x Ecc81/12at7
Speaker Output Options
1 x 16 Ohm cabinet connected to the 16 Ohm output
1 x 8 Ohm cabinet connected to one of the 8 Ohm outputs
2 x 16 Ohm cabinets each connected to one of the 8 Ohm outputs
Height: 27cm, 10.63in
Width: 55cm, 21.65in
Depth: 28cm, 11.02in
Starting with the Ultimate Speaker Demo, an ever-increasing number of the GearTunes audio clips are being tracked using the Radial JCR Reamp. The Reamp was invented by my good friend and colleague John Cuniberti who engineered/co-produced many of Joe Satriani's most infamous recordings.
For GearTunes, reamping allows me to record a track where the guitar "hears" the amp in the room, but initially only the guitar or guitar and effects signal is recorded. This allows me to spend additional time perfecting amp tones and mic placement once I have the performance I'm looking for. One of the byproducts of this process is the creation of GearTunes DI Clips which enable you to play select guitars and effects through your amp by using your mobile device or computer as a reamp device.
For GearTunes DI Clips - and Gear Tune DI Clips ONLY (always found under the DI clips tab for gear that has one), you can play our guitar and effects through your amp. Simply use an unbalanced cable that terminates with an 1/8th inch jack on one end and a 1/4 inch jack on the other. Connect the 1/8th jack to the output of your mobile device or computer and the 1/4 inch jack into the front of your amp. Start off with your amp volume at zero and your mobile device (or computer) volume all the way up to ensure you hit the front end of the amp with enough signal, and then gradually increase the volume of the clean channel on your amp until you reach a level that is not capable of causing damage to your ears or equipment. GearTunes accepts no liability for the use, abuse or misuse of these clips, and playing them into your amp is done exclusively at your own risk.
I am tremendously excited about being able to share GearTunes DI Clips with you as you journey on your quest to find right gear for the music you play! Cheers ~ Doug:)
|Play||Right Click to Download|