The Lehle D.Loop SGoS recommended as the centerpiece of your pedal-board management system, a programmable double looper that takes inactive effects out of the signal path. The loops can be used independently of each other. An adjustable buffer is additionally available in every situation and - because not all effect pedals have a volume controller - can even be used to boost them when necessary. The high-end buffer boost has gain margins of up to 12dB and can also be used seperately!
The jack sockets and internal signal routing are entirely stereo, to permit full-quality use of studio, 19" and stereo effect-pedal units, too. This is assured by the True Bypass characteristics of the Lehle switchers and their gold-plated-contact relays. The signal ground is also switched, to eliminate hum in your effect loops, and a pop-and-click suppression circuit avoids annoying switching noise.
Programming is as easy and as intuitive as you would expect from Lehle products, whether via remote, using MIDI program change commands, as a stand-alone unit, or combined with other SGoS switchers. One very popular combination is to use the Lehle D.Loop SGoS with the Lehle Dual SGoS - they can mutually monitor and control each other, and manage effects and amps. And a simple stereo patch cable is all you need to hit just the right tone!
Starting with the Ultimate Speaker Demo, an ever-increasing number of the GearTunes audio clips are being tracked using the Radial JCR Reamp. The Reamp was invented by my good friend and colleague John Cuniberti who engineered/co-produced many of Joe Satriani's most infamous recordings.
For GearTunes, reamping allows me to record a track where the guitar "hears" the amp in the room, but initially only the guitar or guitar and effects signal is recorded. This allows me to spend additional time perfecting amp tones and mic placement once I have the performance I'm looking for. One of the byproducts of this process is the creation of GearTunes DI Clips which enable you to play select guitars and effects through your amp by using your mobile device or computer as a reamp device.
For GearTunes DI Clips - and Gear Tune DI Clips ONLY (always found under the DI clips tab for gear that has one), you can play our guitar and effects through your amp. Simply use an unbalanced cable that terminates with an 1/8th inch jack on one end and a 1/4 inch jack on the other. Connect the 1/8th jack to the output of your mobile device or computer and the 1/4 inch jack into the front of your amp. Start off with your amp volume at zero and your mobile device (or computer) volume all the way up to ensure you hit the front end of the amp with enough signal, and then gradually increase the volume of the clean channel on your amp until you reach a level that is not capable of causing damage to your ears or equipment. GearTunes accepts no liability for the use, abuse or misuse of these clips, and playing them into your amp is done exclusively at your own risk.
I am tremendously excited about being able to share GearTunes DI Clips with you as you journey on your quest to find right gear for the music you play! Cheers ~ Doug:)
|Play||Right Click to Download|