GearTunes    > Speakers    > Warehouse Guitar Speakers    >

Green Beret, 8 ohm — List: $75.00 Street: $69.00

12" Green Beret - 25 watts

The 12” Green Beret™ guitar speaker brings crunchy cone breakup, growling bass, great headroom, and aggressive mids together better than any other 25 watt speaker. Upgrade for Celestion™ G12M Greenback™.

Mounting Information

    Diameter 12.2”
    Overall depth 5.3”
    Cut-out diameter 11.1”
    Mounting slot dimensions 0.31”
    Number of mounting slots: 4
    Mounting slot PCD 11.7”

Thielle-Small Parameters
Resonant Frequency (Fs) 109.37 Hz
DC Resistance (Re) 6.6 Ohm
Coil Inductance (Le) 8 mH
Mechanical Q (Qms) 9.6061
Electromagnetic Q (Qes) 1.0481
Total Q (Qts) 0.945
Compliance Equivalent Volume (Vas) 1.183 cu ft
Mechanical Compliance of Suspension (Cms) 74.879 mm/N
BL Product (BL) 10.02 T-M
Diaphragm Mass Inc. Airload (Mms) 28.2802 grams
Surface Area of Cone (Sd) 558.645 cm squared
Sound Pressure Level (spl) 98.05 db

Starting with the Ultimate Speaker Demo, an ever-increasing number of the GearTunes audio  clips are being tracked using the Radial JCR Reamp. The Reamp was invented by my good friend and colleague John Cuniberti who engineered/co-produced many of Joe Satriani's most infamous recordings.

For GearTunes, reamping allows me to record a track where the guitar "hears" the amp in the room, but initially only the guitar or guitar and effects signal is recorded. This allows me to spend additional time perfecting amp tones and mic placement once I have the performance I'm looking for. One of the byproducts of this process is the creation of GearTunes DI Clips which enable you to play select guitars and effects through your amp by using your mobile device or computer as a reamp device.

For GearTunes DI Clips - and Gear Tune DI Clips ONLY (always found under the DI clips tab for gear that has one), you can play our guitar and effects through your amp. Simply use an unbalanced cable that terminates with an 1/8th inch jack on one end and a 1/4 inch jack on the other. Connect the 1/8th jack to the output of your mobile device or computer and the 1/4 inch jack into the front of your amp. Start off with your amp volume at zero and your mobile device (or computer) volume all the way up to ensure you hit the front end of the amp with enough signal, and then gradually increase the volume of the clean channel on your amp until you reach a level that is not capable of causing damage to your ears or equipment. GearTunes accepts no liability for the use, abuse or misuse of these clips, and playing them into your amp is done exclusively at your own risk.

I am tremendously excited about being able to share GearTunes DI Clips with you as you journey on your quest to find right gear for the music you play! Cheers ~ Doug:)

Play Right Click to Download