GearTunes    > Recording    > StageTrix    >

Setting Saver — List: $5.99 Street: $4.99

Setting Saver™ -  Keeps your gear dialed in

The StageTrix Setting Saver had been originally announced during the 2012 NAMM Show in Anaheim California for late Spring release. In making sure all beta testing was completed, and striving for affordable recyclable packaging, we are finally ready to start shipping the Setting Saver™.

We have seen multiple ways for people to mark the settings on their amplifiers, effects pedals and mixing consoles, but non seemed easy and convenient. Everything now changes with the introduction of the Setting Saver™. A marker that applies a clean, bright fluorescent green ink to mark your settings. The ink is easily removed by wiping it off with your finger, and will not leave any markings when removed (use only on smooth, non-porus surfaces). Donnie Spada (guitar tech for No Doubt, The Offspring, 311) said this about the Setting Saver™: "Easy to read, easy to clean, no more pieces of tape or grease pens". 

Perfect for amps, pedals, rack equipment, anything with knobs!
No more loosing your settings when you transport your equipment.

Works great on consoles, equalizers, DJ gear, anything with sliders!
Dial in a session, completely change it all, and than go back to the original settings in no time flat.

WARNING! SOME EFFECT PEDALS BY ELECTRO-HARMONICS DO NOT USE A CLEAR COAT OVER THE PEDALS PAINT JOB, THEREFOR IT IS POSSIBLE THAT THE SETTING SAVER MAY DAMAGE THE PEDAL'S FINISH. ALWAYS TRY IN AN INCONSPICUOUS FIRST.

Starting with the Ultimate Speaker Demo, an ever-increasing number of the GearTunes audio  clips are being tracked using the Radial JCR Reamp. The Reamp was invented by my good friend and colleague John Cuniberti who engineered/co-produced many of Joe Satriani's most infamous recordings.

For GearTunes, reamping allows me to record a track where the guitar "hears" the amp in the room, but initially only the guitar or guitar and effects signal is recorded. This allows me to spend additional time perfecting amp tones and mic placement once I have the performance I'm looking for. One of the byproducts of this process is the creation of GearTunes DI Clips which enable you to play select guitars and effects through your amp by using your mobile device or computer as a reamp device.

For GearTunes DI Clips - and Gear Tune DI Clips ONLY (always found under the DI clips tab for gear that has one), you can play our guitar and effects through your amp. Simply use an unbalanced cable that terminates with an 1/8th inch jack on one end and a 1/4 inch jack on the other. Connect the 1/8th jack to the output of your mobile device or computer and the 1/4 inch jack into the front of your amp. Start off with your amp volume at zero and your mobile device (or computer) volume all the way up to ensure you hit the front end of the amp with enough signal, and then gradually increase the volume of the clean channel on your amp until you reach a level that is not capable of causing damage to your ears or equipment. GearTunes accepts no liability for the use, abuse or misuse of these clips, and playing them into your amp is done exclusively at your own risk.

I am tremendously excited about being able to share GearTunes DI Clips with you as you journey on your quest to find right gear for the music you play! Cheers ~ Doug:)

Play Right Click to Download