The first dedicated compact polyphonic pitch arpeggiator effect pedal for electrical guitar! With 8 intuitive and expandable modes, the Arpanoid will work on complex chords as well as single notes in any key. The modes range from one octave down through the root, root through one octave up, one octave down through one octave up and random mode in both major and minor keys. The Step control selects how many notes there are in the sequence, which determines the overall feel and timing of the cycle. The Rate adjusts the speed of the cycle from a slow climb through a fast glide, the center toggle switch changes the direction of the cycle from up, down or up/down and the Wet and Dry controls adjust the levels and the mix. All analog dry signal, true bypass and handmade one at a time in Akron Ohio.

Features:
• The first dedicated polyphonic pitch arpeggiator for electrical guitar!
• 8 Intuitive programs with control over speed, direction and steps
• Adjustable volume for wet and dry signal
• 9v Operation
• Small footprint, measures 4 5/8″ x 2 1/2″ x 2.25″. Top mounted jacks.
• Hand made one at a time in Akron, Ohio.
• MAP: $225.00 USD

Starting with the Ultimate Speaker Demo, an ever-increasing number of the GearTunes audio  clips are being tracked using the Radial JCR Reamp. The Reamp was invented by my good friend and colleague John Cuniberti who engineered/co-produced many of Joe Satriani's most infamous recordings.

For GearTunes, reamping allows me to record a track where the guitar "hears" the amp in the room, but initially only the guitar or guitar and effects signal is recorded. This allows me to spend additional time perfecting amp tones and mic placement once I have the performance I'm looking for. One of the byproducts of this process is the creation of GearTunes DI Clips which enable you to play select guitars and effects through your amp by using your mobile device or computer as a reamp device.

For GearTunes DI Clips - and Gear Tune DI Clips ONLY (always found under the DI clips tab for gear that has one), you can play our guitar and effects through your amp. Simply use an unbalanced cable that terminates with an 1/8th inch jack on one end and a 1/4 inch jack on the other. Connect the 1/8th jack to the output of your mobile device or computer and the 1/4 inch jack into the front of your amp. Start off with your amp volume at zero and your mobile device (or computer) volume all the way up to ensure you hit the front end of the amp with enough signal, and then gradually increase the volume of the clean channel on your amp until you reach a level that is not capable of causing damage to your ears or equipment. GearTunes accepts no liability for the use, abuse or misuse of these clips, and playing them into your amp is done exclusively at your own risk.

I am tremendously excited about being able to share GearTunes DI Clips with you as you journey on your quest to find right gear for the music you play! Cheers ~ Doug:)

Play Right Click to Download