The White Light Overdrive is based on vintage overdrives that defined the sounds of classic hard rock. This vintage voiced stompbox is similar to a vintage DOD 250 or MXR Distortion+, but don’t mistake it for a direct clone of these OD’s of yesteryear. The White Light gives total control over the voice of the dirt along with a modern presence that is both dynamic and responsive to your playing. The Weight control allows you to adjust the saturation and low end, giving you plenty of tonal shaping options. The White Light Overdrive doesn’t discriminate – it likes both humbuckers and single coils, and will add some real 70′s grit to your tone. The Compression switch lets you choose between an open voiced overdrive with more high-mids and bite, or more compression with less bit and flatter mid-range. All analog, true bypass and handmade one at a time by ghouls in the cement bunker of Akron, Ohio.

Measures

4.37″ X 2.37″ X 1.5″ with knobs

Controls

Gain: Controls the amount of distortion
Weight: A multi-functional control, allows the level of saturation, bass response and the over all feel of the device to be altered.
Level: Controls the output
Compression Switch: Less= Open w/ more high-mids and bite. More= Crunchy and compressed with a bit less bite and more flat mids.

Power

9v Battery or any standard 9 volt DC power supply with a negative center 2.1mm barrel.

Starting with the Ultimate Speaker Demo, an ever-increasing number of the GearTunes audio  clips are being tracked using the Radial JCR Reamp. The Reamp was invented by my good friend and colleague John Cuniberti who engineered/co-produced many of Joe Satriani's most infamous recordings.

For GearTunes, reamping allows me to record a track where the guitar "hears" the amp in the room, but initially only the guitar or guitar and effects signal is recorded. This allows me to spend additional time perfecting amp tones and mic placement once I have the performance I'm looking for. One of the byproducts of this process is the creation of GearTunes DI Clips which enable you to play select guitars and effects through your amp by using your mobile device or computer as a reamp device.

For GearTunes DI Clips - and Gear Tune DI Clips ONLY (always found under the DI clips tab for gear that has one), you can play our guitar and effects through your amp. Simply use an unbalanced cable that terminates with an 1/8th inch jack on one end and a 1/4 inch jack on the other. Connect the 1/8th jack to the output of your mobile device or computer and the 1/4 inch jack into the front of your amp. Start off with your amp volume at zero and your mobile device (or computer) volume all the way up to ensure you hit the front end of the amp with enough signal, and then gradually increase the volume of the clean channel on your amp until you reach a level that is not capable of causing damage to your ears or equipment. GearTunes accepts no liability for the use, abuse or misuse of these clips, and playing them into your amp is done exclusively at your own risk.

I am tremendously excited about being able to share GearTunes DI Clips with you as you journey on your quest to find right gear for the music you play! Cheers ~ Doug:)

Play Right Click to Download