Purple on silver limited to 44 units! Orange on silver limited to 46 units! Red on silver is the final production model and is not limited. This item is currently only available at Chicago Music Exchange!
Click here to order purple on silver! Sold Out!
Click here to order orange on silver! Sold Out!
Click here to order red on silver!
The Cloven Hoof is an extension of our popular Hoof fuzz, only more… cloven. We kept the clarity of the Hoof along with the wide range of dirt tones and redesigned everything around it. The Cloven Hoof delivers a grittier, more bass heavy tone with more crunch that can not be achieved with the standard Hoof. We did away with the germanium transistors and replaced them with 4 specially selected silicon transistors for higher gains, cleaner cleans and improved temperature stability. The fuzz control has four times the range of the regular Hoof, it will go from completely clean to an all out fuzz fury with more grind at the top end of the dial. The tone control has been refined to allow a more even sweep with enough mids to handle all the additional low end. The shift control still boosts or cuts the mids and there is still a TON of output on tap. The Cloven Hoof is the perfect solution for those of you who always wished the Hoof had more. Each Cloven Hoof is made by hand in the majestic mountain top village of Akron, Ohio.
Fuzz: Clockwise for heavy, counterclockwise for light.
Tone: Bass to the left, Treble to the right.
Level: Use this control to make the Cloven Hoof louder or quieter.
Shift: This adjusts the mid content, clockwise for scooped mids, counterclockwise for boosted.
4 5/8″ x 2 1/2″ x 2.25″ with knobs
A standard 9 volt DC power supply intended for musical instruments with a negative center 2.1mm barrel or a 9v battery. Do not use any generic adapter (anything from RadioShack or similar). Do not run at higher voltages! Current Draw is about 10ma.
Starting with the Ultimate Speaker Demo, an ever-increasing number of the GearTunes audio clips are being tracked using the Radial JCR Reamp. The Reamp was invented by my good friend and colleague John Cuniberti who engineered/co-produced many of Joe Satriani's most infamous recordings.
For GearTunes, reamping allows me to record a track where the guitar "hears" the amp in the room, but initially only the guitar or guitar and effects signal is recorded. This allows me to spend additional time perfecting amp tones and mic placement once I have the performance I'm looking for. One of the byproducts of this process is the creation of GearTunes DI Clips which enable you to play select guitars and effects through your amp by using your mobile device or computer as a reamp device.
For GearTunes DI Clips - and Gear Tune DI Clips ONLY (always found under the DI clips tab for gear that has one), you can play our guitar and effects through your amp. Simply use an unbalanced cable that terminates with an 1/8th inch jack on one end and a 1/4 inch jack on the other. Connect the 1/8th jack to the output of your mobile device or computer and the 1/4 inch jack into the front of your amp. Start off with your amp volume at zero and your mobile device (or computer) volume all the way up to ensure you hit the front end of the amp with enough signal, and then gradually increase the volume of the clean channel on your amp until you reach a level that is not capable of causing damage to your ears or equipment. GearTunes accepts no liability for the use, abuse or misuse of these clips, and playing them into your amp is done exclusively at your own risk.
I am tremendously excited about being able to share GearTunes DI Clips with you as you journey on your quest to find right gear for the music you play! Cheers ~ Doug:)
|Play||Right Click to Download|