The Uni-Vibe® Chorus/Vibrato is one of the most iconic effects in music history. Since the late ’60s, groundbreaking guitar players have used it to expand the tonal and textural palette of the electric guitar.
The MXR team has just remastered the classic effect for modern players. The MXR Chorus/Vibrato delivers the same chewy, Leslie-sounding goodness with a smaller footprint.
With its simple three-knob interface, you can dial up the iconic effect to your taste in short order. First, use the VIBE switch to select either Chorus Mode—dry signal mixed with pitch-shifted signal—or Vibrato Mode—only pitch-shifted signal. Then, use the LEVEL control to set the effect volume, the SPEED control to set the sweep rate, and the DEPTH control to set overall intensity.
The MXR Uni-Vibe Chorus/Vibrato comes in a Phase 90-sized housing—a fraction of the size and weight of the original Uni-Vibe pedal—and features true bypass switching. Perfect for taking this lush, swirly pedal out on the road.
Starting with the Ultimate Speaker Demo, an ever-increasing number of the GearTunes audio clips are being tracked using the Radial JCR Reamp. The Reamp was invented by my good friend and colleague John Cuniberti who engineered/co-produced many of Joe Satriani's most infamous recordings.
For GearTunes, reamping allows me to record a track where the guitar "hears" the amp in the room, but initially only the guitar or guitar and effects signal is recorded. This allows me to spend additional time perfecting amp tones and mic placement once I have the performance I'm looking for. One of the byproducts of this process is the creation of GearTunes DI Clips which enable you to play select guitars and effects through your amp by using your mobile device or computer as a reamp device.
For GearTunes DI Clips - and Gear Tune DI Clips ONLY (always found under the DI clips tab for gear that has one), you can play our guitar and effects through your amp. Simply use an unbalanced cable that terminates with an 1/8th inch jack on one end and a 1/4 inch jack on the other. Connect the 1/8th jack to the output of your mobile device or computer and the 1/4 inch jack into the front of your amp. Start off with your amp volume at zero and your mobile device (or computer) volume all the way up to ensure you hit the front end of the amp with enough signal, and then gradually increase the volume of the clean channel on your amp until you reach a level that is not capable of causing damage to your ears or equipment. GearTunes accepts no liability for the use, abuse or misuse of these clips, and playing them into your amp is done exclusively at your own risk.
I am tremendously excited about being able to share GearTunes DI Clips with you as you journey on your quest to find right gear for the music you play! Cheers ~ Doug:)
|Play||Right Click to Download|