Volume and gain to pummel the input of amp. Anger knob adjusts the gain with six Fists of Fury positions. Volume knob regulates the overall output level.
The mighty Angry Troll from Way Huge Electronics serves up gorgeous portions of volume and gain to pummel the input of your amp with up to +50dB of gain. It adds bite and punch while transforming your mild mannered tone into a beastly sonic onslaught! The Angry Troll’s two controls interact like a vintage mic pre amp. The Anger knob—a rotary switch with six Fists of Fury positions—adjusts the amount of gain created by the Troll’s op-amp, while the Volume knob regulates the overall output level. High grade components are used for a precisely tuned circuit that works like an extension of your amp. Another tone monster from the mind of Mr. Huge! · Delivers up to +50dB of boost · Precisely tuned to work like an extension of your amp · Adds a little dirt at higher settings · Heavy duty foot switch with quiet relay based true bypass · High grade components for low noise operation.
Starting with the Ultimate Speaker Demo, an ever-increasing number of the GearTunes audio clips are being tracked using the Radial JCR Reamp. The Reamp was invented by my good friend and colleague John Cuniberti who engineered/co-produced many of Joe Satriani's most infamous recordings.
For GearTunes, reamping allows me to record a track where the guitar "hears" the amp in the room, but initially only the guitar or guitar and effects signal is recorded. This allows me to spend additional time perfecting amp tones and mic placement once I have the performance I'm looking for. One of the byproducts of this process is the creation of GearTunes DI Clips which enable you to play select guitars and effects through your amp by using your mobile device or computer as a reamp device.
For GearTunes DI Clips - and Gear Tune DI Clips ONLY (always found under the DI clips tab for gear that has one), you can play our guitar and effects through your amp. Simply use an unbalanced cable that terminates with an 1/8th inch jack on one end and a 1/4 inch jack on the other. Connect the 1/8th jack to the output of your mobile device or computer and the 1/4 inch jack into the front of your amp. Start off with your amp volume at zero and your mobile device (or computer) volume all the way up to ensure you hit the front end of the amp with enough signal, and then gradually increase the volume of the clean channel on your amp until you reach a level that is not capable of causing damage to your ears or equipment. GearTunes accepts no liability for the use, abuse or misuse of these clips, and playing them into your amp is done exclusively at your own risk.
I am tremendously excited about being able to share GearTunes DI Clips with you as you journey on your quest to find right gear for the music you play! Cheers ~ Doug:)
|Play||Right Click to Download|